Expanding Mass Timber & CLT Markets

/
/
/
Expanding Mass Timber & CLT Markets
Expanding Mass Timber & CLT Markets for High Termite Risk Applications

Research Team:

Gerald Presley – OSU, Department of Wood Science and Engineering
Jeff Morell – OSU, Department of Wood Science and Engineering (former)
Scott Noble – Kaiser+Path (former)

Duration:
2020-present
 
Facilities:
University of Hawai’i at Hilo Pharmacy School Field Test Sites
Introduction

In Hawaii, building codes require wood to be pressure treated in order to withstand the dual decay hazards of a tropical climate and Formosan termite activity.  This requirement has limited mass timber on the islands because it can be difficult to treat to the required standard. Individual boards can be treated before being pressed into panels, but it can cause adhesive bonding issues. Dip treatments may not achieve necessary chemical intrusion to repel Formosan termites, and pressure treatment of whole panels is limited by the size of the treatment tanks. This project is part of a pre-existing effort to test a variety of treatment methods to enhance the durability of CLT panels and find options for Hawaiian markets that are both effective and structurally sound.

Research Methods

As part of a precursor investigation of the effects of treatments on adhesive bonding in CLT, the researchers fabricated a series of Douglas-fir 5 x 8 foot CLT panels that included samples treated with 3 different treatments and using 2 different application methods, pre or post layup treatment. The treatment options included a borate pressure treatment, a dip treatment using a borate + organic pesticide preservative solution, and commercial termite treatment composed of a mixture of organic fungicides and pesticides. The panels were either untreated, the lamellas were treated before pressing, or the panels were treated after pressing. Two different adhesive systems were also tested, melamine formaldehyde and polyurethane. The panels were characterized for bond line shear strength and the bond lines and surface were examined under a microscope to visually assess the adhesion as part of a separate project.

Afterward, in 2021, sections of the panels were placed in a termite array at a site on Oahu that termites were known to previously inhabit. Unfortunately, by 2023, no termite activity was seen in the array but ant activity was abundant, indicating the termites were not likely to colonize the original array.  A new array of samples from the original panels was built on a site on the Big Island in 2025 using smaller 6 inch cubes sampled from each of the different treatments installed at the original site.

In 2026, both sites were revisited. The researchers were pleased to discover that termites have since colonized the original array on Oahu!

Key Findings

The researchers completed a full visual assessment on the Oahu site, but the samples will remain on the ground until failure of the control specimens due to termite attack. Final assessments will be completed at that time, but early impressions indicate that there is some difference in activity between the sample treatments, and that edge on the panels treatment has an influence on the termite attack patterns.

Publications

Wainscott, C., Konkler, M., Noble, S., Valenti, J., Morrell, J., & Presley, G. (2024). Characterization of bondlines in cross-laminated timber made with preservative-treated lumber. Wood and Fiber Science, 56(4). https://wfs.swst.org/index.php/wfs/article/view/3304

Funding & Acknowledgments

This research was supported by the USDA-ARS under award number 58-0204-0-099.